The Z-Wave repeaters need to be located in between the end device (lock, motion sensor or switch, etc ) and the hub to be beneficial.Īre any of your Z-Wave locks working as expected or are all of them failing? If one or more are working and those are closer to the hub or a repeater in between, then you know that the non working lock(s) might be too far from the hub and need a repeater or A/C powered Z-Wave device installed to help repeat the Z-Wave signal to the hub. Press and hold the program button for 30 seconds using the SmartKey tool or a paper clip. While holding the Program button, reinsert the battery pack, then release the Program button. Z-Wave repeaters can be a dedicated, like an AEOTEC Range Extender or similar repeater or an A/C powered Z-Wave device and they help "repeat" a Z-Wave signal from a far away device to the hub. A factory reset will delete all codes associated with the lock. Door Handing is the process by which the Kevo Smart Lock determines whether the deadbolt faces the right or the left. Therefore, Z-Wave devices, like a lock, motion sensor, switch, etc either try to talk directly to the hub (direct because they are close enough) or through Z-Wave repeaters (because they are too far or their Z-Wave signal is being blocked by walls, etc. The Z-Wave network is a special frequency and protocol that only Z-Wave devices and the HE C7 hub can communicate. Remove the batteries and replace with a fresh set. Switch 2 if in the up position this will enable the 30 second auto locking feature and if the switch is in the down position this will disable the auto locking feature. This is indicated by the keypad flashing red three times with three beeps. If the latch being used is from an older lock, it will likely not have a tapered latch bolt. The Hubitat Z-Wave network is totally different than your Netgear Orbi WiFi Network. How do I activate/disable the auto lock feature on my SmartCode 909/910 deadbolt or 911/912 lever Located on the interior side of the lock there are 4 switches. SmartCode deadbolts require a tapered latch bolt for ease of operation. No problem, we are all learning with each device and the great people on this forum will also provide some suggestions, which really helps to get the best out of our investment in home automation.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |